Advertisement
YOU ARE HERE: LAT HomeCollections

Ground Rules for Fence Building : Construction: Following some simple guidelines should ensure a stable, long-lasting and attractive product.

August 25, 1990|From POPULAR MECHANICS

Since the first settlers, Americans have always been enthusiastic fence builders.

Early fences contained livestock, while today's fences are used to frame the lawn, define boundaries and provide privacy.

When you consider building a fence, pick a style that will fit its surroundings. Then, measure the proposed perimeter to see how many sections you'll need.

Most fences are built in 6- or 8-foot sections. Posts are commonly 4-by-4s, although 6-by-6s and 8-by-8s are sometimes required for corners and gate posts. Rails, the horizontal bars, are 2-by-4s, and fence pickets or vertical boards may be 1-by-4s or 1-by-6s.

To prevent rust from staining the wood, use aluminum or hot-dipped, galvanized nails and hardware. Estimate the amount of gravel you'll need for drainage. If you set the posts in concrete below the frost line, figure that a 90-pound bag of premixed concrete occupies about two-thirds of a cubic foot.

Use wood that has been pressure-treated with a preservative to resist rot and insects, or wood that resists decay naturally, such as cedar, redwood, cypress or locust.

Begin laying out the fence by finding the corner posts and driving in stakes. Then run mason's twine tautly between two corner stakes. Mark the correct on-center position of each intermediate fence post on the twine with chalk. A plumb line against the mark centers each post on the ground. Drive a stake here.

In loose, sandy soil, it's best to set posts in concrete, but only in frost-free areas or where the concrete will be below the frost line. Generally, set one-third of the post in the ground. Start with the corner posts.

Whether you set a post in gravel or concrete, dig the hole 4 to 6 inches deeper than the post bottom for drainage material--a large flat stone or gravel bed. Flare the hole at the bottom for good support. Then stand the post in the hole on the drainage material.

To set the post in earth, fill in with 6 inches of gravel and tamp it solidly before replacing and tamping the excavated soil. Fill several inches at a time and tamp each layer.

Lay a level vertically on two sides of the post to make sure it's plumb. Add a last layer of rocks at ground level and cap with a tamped-earth cone to drain water away from the post. In concrete, make the hole 6 inches deeper for gravel, set the post on the gravel and fill around it with concrete. Slope the top for drainage.

If posts are set in concrete, let them stand several days while it sets. Otherwise, add the rails immediately.

Rails made of 2-by-4s are sturdy enough to hold most vertical fence boards. Thinner stock might bend. Their ends can be toenailed, cleated or set with metal fasteners. Fence boards are generally 1-inch stock that is 3 inches or more wide. Most are face-nailed to the rails. For easy, even spacing, cut a board to the gap-width and insert it as a guide when nailing on face boards.

Gate posts are larger and deeper-set than the rest of the fence to withstand the added stress. If the gate is to swing properly, the posts must be perfectly plumb. Allow for hinge and latch clearance when measuring. A diagonal brace on the rails strengthens the gate section.

Distributed by AP Newsfeatures.

Advertisement
Los Angeles Times Articles
|
|
|