Advertisement
YOU ARE HERE: LAT HomeCollections

Keeping Your Water Heater Trouble-Free

October 29, 2000|POPULAR MECHANICS | FOR AP SPECIAL FEATURES

Water heaters have relatively few components and are fairly easy to service. When problems do arise, a water heater can send out a mixture of confusing signals. Because trouble can strike any part of your hot-water system, it helps to think in terms of its three basic elements: pipes, including all faucets and hot-water appliances; tank; and the heat source.

Piping systems cause some problems often blamed on the water heater. High operating costs may be traced to a dripping faucet or leaking pipe. A faucet that drips only one drop a second wastes nearly 800 gallons of hot water a year. In such a case, a simple, inexpensive water faucet repair will pay for itself many times over.

Long, uninsulated pipe-runs also waste hot water. When you draw water from a faucet at the end of such a run, hot water must displace water that cooled in the pipe. So, to get a quart of hot water, you must draw several gallons from the tank. Keep the heat from dissipating so quickly by insulating all hot-water pipes.

Hot-water storage tank problems can call for a simple parts replacement or a whole new tank. An aging water system might carry sediment into the tank, or sediment might collect as flakes of calcium and lime.

In electric models, sediment-covered heating elements will burn out quickly. In gas heaters, sediment accumulates in the bottom of the tank, and forms a barrier between the heat source and the water. Steam bubbles percolate through the sediment and cause a continuous rumbling sound. So, if your electric heater burns up lower elements frequently, or if your gas heater rumbles, sediment might be the culprit.

*

To remove sediment, first drain as much water as possible from the tank. Next, with the drain cock still open, turn the water on full pressure to flush the tank. Then, reduce the pressure by half, and, finally, shut off the water and allow the tank to drain completely.

Late-model water heaters have a magnesium rod to coat voids in the porcelain tank lining. An anode sacrifices itself to prevent rust and prolong the tank's life. These rods seldom cause problems, but when they do, it's often a chemical reaction to acids and minerals that gives the water a gassy odor or taste.

To correct this, unscrew the magnesium rod and replace it with an aluminum rod. Most retail plumbing outlets stock them.

A relief valve keeps the heater from exploding if the thermostat sticks. When pressure builds and the water gets too hot, the relief valve opens. However, the valve spring can weaken and release water unnecessarily. To correct this, remove the old valve and screw in a new one.

Advertisement
Los Angeles Times Articles
|
|
|